Enable Iparp Refresh - Extreme Networks ExtremeWare XOS Command Reference Manual

IP Unicast Commands

enable iparp refresh

enable iparp {vr <vr_name>} refresh
Description
Enables IP ARP to refresh its IP ARP entries before timing out.
Syntax Description
vr_name Specifies a virtual router.
Default
Enabled.
Usage Guidelines
IP ARP refresh can only be disabled if IP forwarding is disabled. The purpose of disabling ARP refresh
is to reduce ARP traffic in a high node count layer 2 switching only environment.
If you do not specify a virtual router, the command applies to the current virtual router.
Example
The following command enables IP ARP refresh:
enable iparp refresh
History
This command was available in ExtremeWare XOS 10.1.
The option was added in ExtremeWare XOS 11.0
vr
660 ExtremeWare XOS 11.0 Command Reference Guide