Configure Ospf Area Add Range - Extreme Networks ExtremeWare XOS Command Reference Manual

configure ospf area add range

configure ospf area <area-identifier> add range [<ip-address> <ip-mask> |
<ipNetmask>] [advertise | noadvert] [type-3 | type-7]
Description
Configures a range of IP addresses in an OSPF area to be aggregated.
Syntax Description
area-identifier
ip-address
ip-mask
ipNetmask
advertise
noadvertise
type-3
type-7
Default
N/A.
Usage Guidelines
If advertised, the aggregated IP range is exported as a single LSA by the ABR.
Example
The following command is used to summarize a certain range of IP addresses within an area and export
them out as a single address:
configure ospf area 1.2.3.4 add range 10.1.2.0/24 advertise type-3
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies an OSPF area.
Specifies an IP address
Specifies a subnet mask.
Specifies IP address / Netmask.
Specifies to advertise the aggregated range of IP addresses.
Specifies not to advertise the aggregated range of IP addresses.
Specifies type 3 LSA, summary LSA.
Specifies type 7 LSA, NSSA external LSA.
configure ospf area add range
695