Configure Access-List - Extreme Networks ExtremeWare XOS Command Reference Manual

Security Commands

configure access-list

configure access-list <aclname> [any | ports <portlist> | vlan <vlanname>]
{ingress}
Description
Configures an access list to the specified interface.
Syntax Description
aclname
portlist
vlanname
Default
The default direction is ingress.
Usage Guidelines
The access list applied in this command is contained in a text file created externally to the switch. The
file is transferred to the switch using TFTP before it is applied to the ports. The ACL name is the file
name without its ".pol" extension. For example, the ACL blocknetfour would be in the file blocknetfour.pol.
Specifying the keyword
This ACL is evaluated for ports without a specific ACL applied to it, and is also applied to packets that
do not match the ACL applied to the interface.
Example
The following command configures the ACL test to port 1:2 at ingress:
configure access-list test ports 1:2
The following command configures the ACL mydefault as the wildcard ACL:
configure access-list mydefault any
History
This command was available in ExtremeWare XOS 10.1.
The VLAN option was first available in ExtremeWare XOS 11.0
414
Specifies the ACL name. The name can be from 1-32 characters long.
Specifies the ports on which this ACL is applied.
Specifies the VLAN on which this ACL is applied.
applies the ACL to all the ports, and is referred to as the wildcard ACL.
any
ExtremeWare XOS 11.0 Command Reference Guide