BGP Commands
disable bgp neighbor capability
disable bgp neighbor [all | <remoteaddr>] capability [ipv4-unicast |
ipv4-multicast | route-refresh]
Description
This command disables BGP Multiprotocol (MP) and route-refresh capabilities for neighbor.
Syntax Description
all
remoteaddr
ipv4-unicast
ipv4-multicast
route-refresh
Default
All capabilities are disabled by default.
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
This command disables BGP Multiprotocol and route-refresh capabilities for one or all neighbors. After
the capabilities have been enabled, the BGP neighbor will announce its capabilities to neighbors in an
OPEN message.
Example
The following command disables the route-refresh feature for all neighbors:
disable bgp neighbor all route-refresh
History
This command was available in ExtremeWare XOS 10.1.
842
Specifies all neighbors.
Specifies an IP address of the BGP neighbor.
Specifies BGP MP unicast capabilities.
Specifies BGP MP multicast capabilities.
Specifies ROUTE-REFRESH message capabilities.
ExtremeWare XOS 11.0 Command Reference Guide