Configure Tacacs Server - Extreme Networks ExtremeWare XOS Command Reference Manual

configure tacacs server

configure tacacs [primary | secondary] server [<ipaddress> | <hostname>]
{<tcp_port>} client-ip <ipaddress> {vr <vr_name>}
Description
Configures the server information for a TACACS+ authentication server.
Syntax Description
primary
secondary
ipaddress
hostname
tcp_port
ipaddress
vr_name
Default
TACACS+ uses TCP port 49. The default virtual router is VR-0, the management virtual router
Usage Guidelines
Configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
Use of the <hostname> parameter requires that DNS be enabled.
Example
The following command configures server tacacs1 as the primary TACACS+ server for client switch
10.10.20.35 using a virtual router interface of VR-2:
configure tacacs primary server tacacs1 client-ip 10.10.20.35 vr vr-2
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Configures the primary TACACS+ server.
Configures the secondary TACACS+ server.
The IP address of the TACACS+ server being configured.
The host name of the TACACS+ server being configured.
The TCP port to use to contact the TACACS+ server.
The IP address used by the switch to identify itself when communicating with
the TACACS+ server.
Specifies the virtual router on which the client IP is located.
configure tacacs server
423