Configure Stpd Maxage - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

configure stpd maxage

configure stpd <stpd_name> maxage <seconds>
Description
Specifies the maximum age of a BPDU in the specified STPD.
Syntax Description
stpd_name
seconds
Default
20 seconds.
Usage Guidelines
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If your STPD has a name
unique only to that STPD, the keyword
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
The range for the
<seconds>
Note that the time must be greater than, or equal to 2 * (Hello Time + 1) and less than, or equal to 2 *
(Forward Delay –1).
Example
The following command sets the maximum age of STPD1 to 30 seconds:
configure stpd stpd1 maxage 30
History
This command was available in ExtremeWare XOS 10.1.
504
Specifies an STPD name on the switch.
Specifies the maxage time in seconds. The range is 6 to 40 seconds.
is optional.
stpd
parameter is 6 through 40 seconds.
ExtremeWare XOS 11.0 Command Reference Guide