Extreme Networks ExtremeWare XOS Command Reference Manual page 321

Table 10: Default target log characteristics
Target
console display no
memory buffer
NVRAM
primary MSM
backup MSM
session
syslog
If the condition for the
sent to the backup MSM. When the backup MSM receives the event, it will see if any of the local targets
(nvram, memory, or console) are matched. If so it gets processed. The
disabled on the backup MSM, as they are handled on the primary. If the condition for the
target is met by a message generated on the backup, the event is sent to the primary MSM.
Note that the
active on the backup MSM.
The built-in filter, DefaultFilter, and a severity level of
values may be overridden on a per-session basis using the
and specify the target as
changes:
configure log target session filter <filter name> {severity <severity> {only}}
Configuration changes to the current session target are in effect only for the duration of the session, and
are not saved in FLASH memory. The
changes are desired to be temporary. If changes to the console-display are to be permanent (saved to
FLASH memory), use the following form of the command:
configure log target console filter <filter name> {severity <severity> {only}}
Example
The following command sends log messages to the previously syslog host at 10.31.8.25, port 8993, and
facility
local3
configure log target syslog 10.31.8.25:8993 local3 filter myFilter severity warning
The following command sends log messages to the current session, that pass the filter myFilter and are
of severity
warning
configure log target session filter myFilter severity warning
History
This command was first available in ExtremeWare XOS 10.1.
The
primary-msm
ExtremeWare XOS 11.0 Command Reference Guide
Enabled Severity Level
info
yes debug-data
yes warning
yes error
yes error
no info
no debug-data
target is met by a message generated on the primary, the event is
backup-msm
target is only active on the primary MSM, and the
backup-msm
. Use the following form of the command for per-session configuration
session
, that pass the filter myFilter and are of severity
and above:
and options were first available in ExtremeWare XOS 11.0.
backup-msm
are used for each new telnet session. These
info
configure log target filter
option can also be used on the console display, if the
session
warning
configure log target filter
and targets are
session syslog
primary-msm
target is only
primary-msm
command
and above:
321