Configure Vlan Add Ports Stpd - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

configure vlan add ports stpd

configure vlan <vlan_name> add ports [all | <port_list>] {tagged |
untagged} {nobroadcast} stpd <stpd_name> {[dot1d | emistp | pvst-plus]}
Description
Adds one or more ports in a VLAN to a specified STPD.
Syntax Description
vlan_name
all
port_list
tagged
untagged
nobroadcast
stpd_name
dot1d
emistp
pvst-plus
Default
All ports are in mode, except those in STPD s0, whose default setting is
emistp
Usage Guidelines
To create a VLAN, use the
command.
This command adds a list of ports to a VLAN and a specified STPD at the same time provided the
carrier VLAN already exists on the same set of ports. You can also specify the encapsulation mode for
those ports.
If you see an error similar to the following:
Error: Cannot add VLAN default port 3:5 to STP domain
You might be attempting to add:
• Another 802.1D mode STP port to a physical port that already contains an 802.1D mode STP port
(only one 802.1D encapsulation STP port can be configured on a particular STP port)
• A carrier VLAN port to a different STP domain than the carrier VLAN belongs
• A VLAN/port for which the carrier VLAN does not yet belong
514
Specifies a VLAN name.
Specifies all of the ports to be included in the STPD.
Specifies the port or ports to be included in the STPD.
Specifies the ports should be configured as tagged.
Specifies the ports should be configured as untagged.
Prevents broadcasts, multicasts, and unknowns from being transmitted on
these ports.
Specifies an STPD name on the switch.
Specifies the STP encapsulation mode of operation to be 802.1d.
Specifies the STP encapsulation mode of operation to be EMISTP.
Specifies the STP encapsulation mode of operation to be PVST+.
command. To create an STP domain, use the
create vlan
mode.
dot1d
create stpd
ExtremeWare XOS 11.0 Command Reference Guide