Configure Pim Crp Static - Extreme Networks ExtremeWare XOS Command Reference Manual

configure pim crp static

configure pim crp static <ip_address> [none | <policy>] {<priority>
[0-254]}
Description
Configures a rendezvous point and its associated groups statically, for PIM sparse mode operation.
Syntax Description
ip_address
none
policy
priority
Default
The default setting for priority is 0, which indicates highest priority.
Usage Guidelines
In PIM-SM, the router sends a join message to the rendezvous point (RP). The RP is a central multicast
router that is responsible for receiving and distributing multicast packets. If you use a static RP, all
switches in your network must be configured with the same RP address for the same group (range).
The policy file contains a list of multicast group addresses served by this RP.
Example
The following command statically configures an RP and its associated groups defined in policy file
rp-list:
configure pim crp static 10.0.3.1 rp-list
The following is a sample policy file:
entry extreme1 {
if match any {
}
then {
nlri
permit ;
}
}
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies a static CRP address.
Deletes the static rendezvous point.
Specifies a policy file name.
Specifies a priority setting. The range is 0 - 254.
224.0.0.0/4 ;
nlri 239.255.0.0/24 ;
nlri 232.0.0.0/8 ;
nlri 238.1.0.0/16 ;
nlri 232.232.0.0/20 ;
configure pim crp static
895