Configure Radius-Accounting Server - Extreme Networks ExtremeWare XOS Command Reference Manual

Security Commands

configure radius-accounting server

configure radius-accounting [primary | secondary] server [<ipaddress> |
<hostname>] {<tcp_port>} client-ip [<ipaddress>] {vr <vr_name>}
Description
Configures the RADIUS accounting server.
Syntax Description
primary
secondary
ipaddress
hostname
tcp_port
ipaddress
vr_name
Default
The default UDP port setting is 1813. The default virtual router is VR-0, the management virtual router.
Usage Guidelines
Use this command to specify the radius accounting server.
The accounting server and the RADIUS authentication server can be the same.
Use of the <hostname> parameter requires that DNS be enabled.
Example
The following command configures RADIUS accounting on host
(1813) for use by the RADIUS client on switch 10.10.20.30 using a virtual router interface of VR-2:
configure radius-accounting primary server radius1 client-ip 10.10.20.30 vr vr-2
History
This command was available in ExtremeWare XOS 10.1.
418
Configure the primary RADIUS accounting server.
Configure the secondary RADIUS accounting server.
The IP address of the accounting server being configured.
The host name of the accounting server being configured.
The UDP port to use to contact the RADIUS accounting server.
The IP address used by the switch to identify itself when communicating with
the RADIUS accounting server.
Specifies the virtual router on which the client IP is located.
using the default UDP port
radius1
ExtremeWare XOS 11.0 Command Reference Guide