Extreme Networks ExtremeWare XOS Command Reference Manual page 337

configure sys-health-check interval
If backplane diagnostic packets are enabled on a slot and you modify the polling interval on the switch,
the new interval value takes precedence. For example, if you configure the interval to 7 seconds, the
polling interval is updated to 70 seconds on all slots with backplane diagnostics disabled. On the slot
with backplane diagnostic packets enabled, backplane diagnostic packets are sent and polling occurs
every 7 seconds.
To return to the default interval setting of 6 seconds, and the default polling interval of 60 seconds,
specify 6 for the .
interval
NOTE
Extreme Networks does not recommend configuring an interval of less than 6 seconds. Doing this can
cause excessive CPU utilization.
Example
The following example assumes that you enabled backplane diagnostic packets on a specific I/O slot.
The following command configures the backplane diagnostic packet interval to 8 seconds and the
polling interval to 80 seconds:
configure sys-health-check interval 8
History
This command was first available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide 337