Configure Diffserv Replacement - Extreme Networks ExtremeWare XOS Command Reference Manual

QoS Commands

configure diffserv replacement

configure diffserv replacement [qosprofile <qosprofile> | priority <value>]
code-point <code_point>
Description
Configures the default egress DiffServ replacement mapping.
Syntax Description
qosprofile
value
code_point
Default
N/A.
Usage Guidelines
NOTE
Extreme Networks recommends that you use the
parameter.
The default QoS Profile to 802.1p priority value to code point mapping is shown in the following table:
802.1p Priority
QoS Profile Value
QP1 0
QP2 1
QP3 2
QP4 3
QP5 4
QP6 5
QP7 6
QP8 7
Example
The following command specifies that a code point value of 5 should be used to replace the DiffServ
(TOS) bits in packets in QP2:
configure diffserv replacement qosprofile qp2 code-point 5
284
Specifies a QoS profile.
Specifies the 802.1p priority value.
Specifies a 6-bit value to be used as the replacement code point in the
DiffServ (IP-TOS byte) of the IP header.
qosprofile <qosprofile>
Code Point
0
8
16
24
32
40
48
56
value to configure this
ExtremeWare XOS 11.0 Command Reference Guide