VRRP Commands
configure vrrp vlan vrid add ipaddress
configure vrrp vlan <vlan_name> vrid <vridval> add <ipaddress>
Description
Associates a virtual IP address with a specific VRRP virtual router.
Syntax Description
vlan_name
vridval
ipaddress
Usage Guidelines
The restrictions on this command are as follows:
• If the priority of the VRRP virtual router is 255, the IP address to be added must be owned by the
VLAN on which the VRRP virtual router exists. If the priority is not 255, the IP address must not be
owned by that VLAN.
• When a VRRP virtual router is enabled, it must have at least one virtual IP address.
Example
Create a VLAN named vlan-1 with an ipaddress of 10.1.2.2 and a VRRP VRID of 1:
create vlan vlan-1
configure vlan vlan-1 ipaddress 10.1.2.2
create vrrp vlan-1 vrid 1
The following example associates IP address 10.1.2.3 to VLAN vlan-1:
configure vrrp vlan vlan-1 vrid 1 add 10.1.2.3
History
This command was first available in ExtremeWare XOS 10.1.
584
Specifies the name of a VRRP VLAN.
Specifies a VRRP Virtual Router ID (VRID). Value can be in the range of
1-255.
Specifies the IP address of the virtual router in which this device participates.
ExtremeWare XOS 11.0 Command Reference Guide