Configuration and Image Commands
install bootrom
install bootrom <filename> {reboot}
Description
Installs a new version of the ExtremeWare XOS bootrom image.
Syntax Description
filename
reboot
Default
N/A.
Usage Guidelines
When you download a BootROM image, the system asks if you want to install the image immediately
after the download is finished. If you choose to install the image at a later time, use this command to
install the software on the switch.
The BootROM image file is a .xbr file, and this file contains the executable code.
Example
The following command installs the bootrom image file bd10k-1.0.1.5-bootrom.xbr:
install bootrom bd10k-1.0.1.5-bootrom.xbr
You will see output similar to the following:
Installing bootrom...
Writing MSM B bootrom
........................................................................
........................................................................
.........................
Verifying Flash contents...
........................................................................
........................................................................
........................................................................
........................................................................
....................................................
bootrom written.
Writing MSM A bootrom
........................................................................
........................................................................
.........................
Verifying Flash contents...
........................................................................
........................................................................
........................................................................
........................................................................
932
Specifies the BootROM image file.
Reboots the switch after the image is installed.
ExtremeWare XOS 11.0 Command Reference Guide