Enable Stpd Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

enable stpd ports

enable stpd <stpd_name> ports [all | <port_list>]
Description
Enables the STP protocol on one or more ports.
Syntax Description
stpd_name
all
port_list
Default
Enabled.
Usage Guidelines
If you create an STPD with a unique name, the keyword
If STP is enabled for a port, BPDUs are generated and processed on that port if STP is enabled for the
associated STPD.
You must configure one or more STPDs before you can use the
create an STPD, use the
and experience with STP, you can configure the STPD using the
the default STP parameters are adequate for most networks.
Example
The following command enables slot 2, port 4 on an STPD named Backbone_st:
enable stpd backbone_st ports 2:4
History
This command was available in ExtremeWare XOS 10.1.
526
Specifies an STPD on the switch.
Specifies all ports for a given STPD.
Specifies one or more slots and ports. May be in the form 2:*, 2:5, 2:6-2:8.
create stpd <stpd_name>
is optional.
stpd
enable stpd ports
command. If you have considerable knowledge
configure stpd
command. To
commands. However,
ExtremeWare XOS 11.0 Command Reference Guide