Configure Bgp Neighbor Route-Policy - Extreme Networks ExtremeWare XOS Command Reference Manual

configure bgp neighbor route-policy

configure bgp neighbor [<remoteaddr> | all] {address-family [ipv4-unicast |
ipv4-multicast]} route-policy [in | out] [none | <policy>]
Description
Configures a route map filter for a neighbor.
Syntax Description
remoteaddr
all
address-family
in
out
none
policy
Default
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
The policy can be installed on the input or output side of the router. The policy is used to modify or
filter the NLRI information and the path attributes associated with it when exchanging updates with the
neighbor.
Example
The following command configures the route-policy filter for a neighbor based on the policy nosales:
configure bgp neighbor 192.168.1.22 route-policy in nosales
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies an IP address.
Specifies all neighbors.
The address family. BGP supports two address families: IPv4 Unicast and
IPv4 Multicast
Specifies to install the filter on the input side.
Specifies to install the filter on the output side.
Specifies to remove the filter.
Specifies a policy.
configure bgp neighbor route-policy
805