Configure Pim Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

configure pim add vlan

configure pim add vlan [<vlan_name> | all] {dense | sparse}
Description
Enables PIM on an IP interface.
Syntax Description
vlan_name
all
dense
sparse
Default
Dense.
Usage Guidelines
When an IP interface is created, per-interface PIM configuration is disabled by default.
The switch supports both dense mode and sparse mode operation. You can configure dense mode or
sparse mode on a per-interface basis. After they are enabled, some interfaces can run dense mode, while
others run sparse mode.
Example
The following command enables PIM-DM multicast routing on VLAN accounting:
configure pim add vlan accounting dense
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies a VLAN name.
Specifies all VLANs.
Specifies PIM dense mode (PIM-DM).
Specifies PIM sparse mode (PIM-SM).
configure pim add vlan
893