Configure Radius Server - Extreme Networks ExtremeWare XOS Command Reference Manual

configure radius server

configure radius [primary | secondary] server [<ipaddress> | <hostname>]
{<udp_port>} client-ip [<ipaddress>] {vr <vr_name>}
Description
Configures the primary and secondary RADIUS authentication server.
Syntax Description
primary
secondary
ipaddress
hostname
udp_port
ipaddress
vr_name
Default
The default UDP port setting is 1812. The default virtual router is VR-0, the management virtual router.
Usage Guidelines
Use this command to specify RADIUS server information.
Use of the <hostname> parameter requires that DNS be enabled.
The RADIUS server defined by this command is used for user name authentication and CLI command
authentication.
Example
The following command configures the primary RADIUS server on host
port (1812) for use by the RADIUS client on switch 10.10.20.30 using a virtual router interface of VR-2:
configure radius primary server radius1 client-ip 10.10.20.30 vr vr-2
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Configures the primary RADIUS authentication server.
Configures the secondary RADIUS authentication server.
The IP address of the server being configured.
The host name of the server being configured.
The UDP port to use to contact the RADIUS authentication server.
The IP address used by the switch to identify itself when communicating with
the RADIUS authentication server.
Specifies the virtual router on which the client IP is located
configure radius server
using the default UDP
radius1
415