Configure Bgp Neighbor Password - Extreme Networks ExtremeWare XOS Command Reference Manual

configure bgp neighbor password

configure bgp neighbor [all | <remoteaddr>] password [none | <tcpPassword>]
Description
Configures an MD5 secret password for a neighbor.
Syntax Description
all
remoteaddr
none
tcpPassword
Default
N/A.
Usage Guidelines
When a password is configured, TCP MD5 authentication is enabled on the TCP connection that is
established with the neighbor.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
To change any one of the following parameters you must disable and re-enable the peer session:
• timer
• source-interface
• soft-in-reset
• password
Changing a route reflector client will automatically disable and enable the peer session.
Example
The following command configures the password for a neighbor as Extreme:
configure bgp neighbor 192.168.1.5 password extreme
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies all neighbors.
Specifies an IP address of a BGP neighbor.
Specifies not to use a password
Specifies a password string.
configure bgp neighbor password
803