Configure Vr Add Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Virtual Routers

configure vr add ports

configure vr <vr-name> add ports <portlist>
Description
Assigns a list of ports to the virtual router specified.
Syntax Description
vr-name
portlist
Default
By default, all ports are assigned to the virtual router, VR-Default.
Usage Guidelines
When a new virtual router is created, by default, no ports are assigned, no VLAN interface is created,
and no support for any routing protocols is added. Use this command to assign ports to a virtual router.
Since all ports are initially assigned to VR-Default, you may need to delete the desired ports first from
the virtual router where they reside, before you add them to the desired virtual router.
Example
The following command adds all the ports on slot 2 to the virtual router vr-acme:
configure vr vr-acme add ports 2:*
History
This command was first available in ExtremeWare XOS 11.0.
266
Specifies the name of the virtual router.
Specifies the ports to add to the virtual router.
ExtremeWare XOS 11.0 Command Reference Guide