Unconfigure Qosprofile Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

unconfigure qosprofile ports

unconfigure qosprofile {ingress | egress} ports [<port_list>|all]
Description
Returns the ingress rate shaping parameters, which is an ingress QoS profile, or the egressing QoS
values to default values.
Syntax Description
ingress
egress
port_list
all
Default
Ingress QoS is disabled by default.
• Minimum bandwidth—0%
• Maximum bandwidth—100%
• Minimum committed and peak rates—1 Kbps
• Maximum committed and peak rates—varies by I/O module:
— 1G I/O module—1,000 Mbps
— 10G I/O module—10,000 Mbps
• Ingress priority—By default, each qosprofile is assigned a different priority level, which varies by
I/O module:
— 1G I/O module:
• IQP1 - 1 Low
• IQP2 - 1, LowHi
— 10G I/O module:
• IQP1 - 1, Low
• IQP2 - 2, LowHi
ExtremeWare XOS 11.0 Command Reference Guide
Specifies all ingress QoS profiles for specified ports. The default ingress
values are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
Specifies an egress QoS profile for specified ports. The default egress values
are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default
Specifies a list of slots and ports to which the parameters apply. May specify
in the form 3-5, 2:5, 2:6-2:8.
Specifies that this applies to all ports on the device.
unconfigure qosprofile ports
307