Configure Tacacs-Accounting Server - Extreme Networks ExtremeWare XOS Command Reference Manual

Security Commands

configure tacacs-accounting server

configure tacacs-accounting [primary | secondary] server [<ipaddress> |
<hostname>] {<udp_port>} client-ip <ipaddress> {vr <vr_name>}
Description
Configures the TACACS+ accounting server.
Syntax Description
primary
secondary
ipaddress
hostname
tcp_port
ipaddress
vr_name
Default
Unconfigured. The default virtual router is VR-0, the management virtual router.
Usage Guidelines
You can use the same TACACS+ server for accounting and authentication.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
Example
The following command configures server tacacs1 as the primary TACACS+ accounting server for client
switch 10.10.20.35 using a virtual router interface of VR-2:
configure tacacs-accounting primary server tacacs1 client-ip 10.10.20.35 vr vr-2
History
This command was available in ExtremeWare XOS 10.1.
426
Configures the primary TACACS+ accounting server.
Configures the secondary TACACS+ accounting server.
The IP address of the TACACS+ accounting server being configured.
The host name of the TACACS+ accounting server being configured.
The TCP port to use to contact the TACACS+ server.
The IP address used by the switch to identify itself when communicating with
the TACACS+ accounting server.
Specifies the virtual router on which the client IP is located.
ExtremeWare XOS 11.0 Command Reference Guide