BGP Commands
enable bgp neighbor soft-in-reset
enable bgp neighbor [all | <remoteaddr>] {address-family [ipv4-unicast |
ipv4-multicast]} soft-in-reset
Description
Enables the soft input reset feature.
Syntax Description
all
remoteaddr
address-family
Default
Disabled.
If no address family is specified, IPv4 unicast is the default.
Usage Guidelines
Disabling the soft input reset feature can potentially limit the amount of system memory consumed by
the RIB-in.
Example
The following command enables the soft recognition feature:
enable bgp neighbor 192.168.1.17 soft-in-reset
History
This command was available in ExtremeWare XOS 10.1.
860
Specifies all neighbors.
Specifies an IP address of a BGP neighbor.
The address family. BGP supports two address families: IPv4 Unicast and
IPv4 Multicast.
ExtremeWare XOS 11.0 Command Reference Guide