Show Iproute Origin - Extreme Networks ExtremeWare XOS Command Reference Manual

IP Unicast Commands

show iproute origin

show iproute origin [all-bgp | all-ospf | ebgp | ibgp | direct | static |
blackhole | rip | bootp | icmp | ospf-intra | ospf-inter | ospf-extern1 |
ospf-extern2]} {vr <vrname>}
Description
Displays the contents of the IP routing table or the route origin priority.
Syntax Description
origin
Default
N/A.
Usage Guidelines
Policies for IP routing can be configured based on the route origin. When routes are added to the IP
routing table from various sources, the routing policies configured for the origin of the route is applied
to the route. After matching on specified characteristics, the characteristics for the route can be modified
using the policy. The characteristics that can be matched and modified are dependent on the origin of
the route. Policies for IP routing can be dynamically changed. In the case of direct and static route
origins, the changes are reflected immediately. In the case of routes that are sourced from other origin,
the changes are reflected within 30 seconds.
Example
The following command displays the route origin for all bgp routes:
show iproute origin all-bgp
History
This command was available in ExtremeWare XOS 10.1.
676
Specifies a display of the route map origin.
ExtremeWare XOS 11.0 Command Reference Guide