Extreme Networks ExtremeWare XOS Command Reference Manual page 931

download image
that command, all the functionality, and command line interface (CLI) commands, of the module will be
available.
Example
The following command downloads the switch software image from the TFTP server at 10.10.15.04,
from the file named bd10k-11.0.0.25.xos:
download image 10.10.15.04 bd10K-11.0.0.25.xos
If you download the image into the active partition, you see output similar to the following:
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes
Downloading to
MSM-A..............................................................
Downloading to MSM-B..................................
Image will be installed to the active partition, a reboot required. Do
you want to continue? (y/n) Yes
Installing to primary partition!
Installing to
MSM-
B..............................................................................
...............................................................................
...............................................................................
...............................................................................
.....................................
Installing to
MSM-
A..............................................................................
...............................................................................
...............................................................................
............................
If you answer yes to installing the image, the switch reboots upon completion of the installation.
History
This command was first available in ExtremeWare XOS 10.1.
The option was added in ExtremeWare XOS 11.0.
memorycard
ExtremeWare XOS 11.0 Command Reference Guide 931