Configure Stpd Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure stpd add vlan

configure stpd <stpd_name> add vlan <vlan_name> ports [all | <port_list>]
{[dot1d | emistp | pvst-plus]}
Description
Adds all ports or a list of ports within a VLAN to a specified STPD.
Syntax Description
stpd_name
vlan_name
all
port_list
dot1d
emistp
pvst-plus
Default
Ports in the default STPD (s0) are in
Ports in user-created STPDs are in
Usage Guidelines
To create an STP domain, use the
command.
In an EMISTP or PVST+ environment, this command adds a list of ports within a VLAN to a specified
STPD provided the carrier VLAN already exists on the same set of ports. You can also specify the
encapsulation mode for those ports.
In an MSTP environment, you do not need a carrier VLAN. A CIST controls the connectivity of
interconnecting MSTP regions and sends BPDUs across the regions to communicate region status. You
must use the dot1d encapsulation mode in an MSTP environment.
You cannot configure STP on the following ports:
Mirroring target ports
●
Software-controlled redundant ports
●
Netlogin ports
●
If you see an error similar to the following:
Error: Cannot add VLAN default port 3:5 to STP domain
ExtremeWare XOS 11.5 Command Reference Guide
Specifies an STPD name on the switch.
Specifies a VLAN name.
Specifies all of the ports in the VLAN to be included in the STPD.
Specifies the port or ports to be included in the STPD.
Specifies the STP encapsulation mode of operation to be 802.1D.
Specifies the STP encapsulation mode of operation to be EMISTP.
Specifies the STP encapsulation mode of operation to be PVST+.
mode.
dot1.d
mode.
emistp
command. To create a VLAN, use the
create stpd
configure stpd add vlan
create vlan
1175