Show Sflow Configuration - Extreme Networks ExtremeWare XOS Command Reference Manual

show sflow configuration

show sflow {configuration}
Description
Displays the current sFlow configuration.
Syntax Description
This command has no arguments or variables
Default
N/A.
Usage Guidelines
This command displays the sFlow configuration of your system.
The following fields are displayed:
• Global Status—sFlow is globally enabled or disabled
• Polling interval—How often data from each sampler is sent to the collector, in seconds
• Sampling rate—Packets are sampled, on average, once for every rate-number of packets
• Maximum cpu sample limit—Maximum number of packets per second sampled before sample
throttling takes effect
• Agent IP—Source IP address for sFlow data packets sent from this switch
• Collectors—To which IP address and port, and from which virtual router, the sFlow packets are sent
• Port Status—Enabled or disabled for statistics gathering
• Port Sample-rate—Shows the sampling rate configured for the port and the actual rate if CPU
throttling has taken effect
• Port Subsampling factor—See the command
Example
To display the sFlow configuration on your system, use the following command:
show sflow
The output from this command is similar to the following:
SFLOW Global Configuration
Global Status: enabled
Polling interval: 20
Sampling rate: 8192
Maximum cpu sample limit: 2000
SFLOW Configured Agent IP: 10.203.2.38 Operational Agent IP: 10.203.2.38
Collectors
Collector IP 10.201.6.250, Port 6343, VR "VR-Mgmt"
SFLOW Port Configuration
ExtremeWare XOS 11.0 Command Reference Guide
configure sflow ports sample-rate
show sflow configuration
for details
393