Extreme Networks ExtremeWare XOS Command Reference Manual page 890

IP Multicast Commands
if {
} then {
deny;
}
}
NOTE
The switch will not validate any IP address in the policy file used in this command. Therefore, slow-path
flooding should be used only for streams which are very infrequent, such as control packets. It should
not be used for multicast data packets. This option overrides any default mechanism of hardware
forwarding (with respect to IGMP, PIM, or DVMRP) so it should be used with caution.
Slow path flooding will be done within the L2 VLAN only.
Use the option to effectively disable slow path flooding.
none
You can use the
show ipconfig
listed in the IGMP snooping section of the display.
Example
The following command configures the multicast data stream specified in access1 for slow path flooding:
configure igmp snooping flood-list access1
The following command specifies that no policy file is to be used, this effectively disabling slow path
flooding:
configure igmp snooping flood-list none
History
This command was available in ExtremeWare XOS 10.1.
890
command to see the configuration of slow path flooding. It will be
ExtremeWare XOS 11.0 Command Reference Guide