Configure Sflow Agent Ipaddress - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure sflow agent ipaddress

configure sflow agent {ipaddress} <ip-address>
Description
Configures the sFlow agent's IP address.
Syntax Description
ip-address Specifies the IP address from which sFlow data is sent on the switch.
Default
The default configured IP address is 0.0.0.0, but the effective IP address is the management port IP
address.
Usage Guidelines
This command allows you to configure the IP source address that the sFlow agent uses when sending
data. Typically, you would set this to the IP address used to identify the switch in the network
management tools that you use. The default configured value is 0.0.0.0, but the switch will use the
management port IP address if the configuration is not changed.
Both the commands and will reset the agent
unconfigure sflow unconfigure sflow agent
parameter to the default.
Example
The following command sets the source IP address to 10.2.0.1 for UDP datagrams sent out by the sFlow
agent:
configure sflow agent ipaddress 10.2.0.1
History
This command was first available in ExtremeWare XOS 11.0.
330 ExtremeWare XOS 11.0 Command Reference Guide