Enable Diffserv Replacement Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

enable diffserv replacement ports

enable diffserv replacement ports [<port_list> | all]
Description
Enables the DiffServ code point to be overwritten in IP packets transmitted by the switch.
Syntax Description
port_list
all
Default
N/A.
Usage Guidelines
The diffserv replacement feature is disabled by default.
NOTE
The port in this command is the ingress port.
Eight user-defined DiffServ code points can be configured on each port. The QoS profile is used to select
one of the eight code points.
If you are using DiffServ for QoS parameters, Extreme Networks recommends that you also configure
802.1p or port-based QoS parameters to ensure that high-priority traffic is not dropped prior to reaching
the MSM.
Example
The following command enables DiffServ replacement on selected ports:
enable diffserv replacement ports 5:3,5:5,6:2
History
This command was first available in ExtremeWare XOS 11.0.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies a list of slots and ports to which the parameters apply. May be in the
form 3-5, 2:5, 2:6-2:8.
Specifies that DiffServ replacement should be enabled for all ports.
enable diffserv replacement ports
297