Enable Icmp Address-Mask - Extreme Networks ExtremeWare XOS Command Reference Manual

enable icmp address-mask

enable icmp address-mask
enable icmp address-mask {vlan <name>}
Description
Enables the generation of an ICMP address-mask reply on one or all VLANs.
Syntax Description
name Specifies a VLAN name.
Default
Disabled.
Usage Guidelines
Enables the generation of an ICMP address-mask reply (type 18, code 0) when an ICMP address mask
request is received.The default setting is enabled. If a VLAN is not specified, the command applies to all
IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command enables the generation of an ICMP address-mask reply on VLAN accounting:
enable icmp address-mask vlan accounting
History
This command was available in ExtremeWare XOS 10.1.
The default was changed to disabled in ExtremeWare 11.0.
ExtremeWare XOS 11.0 Command Reference Guide 651