Flowcontrol; Interface - Dell PowerEdge M420 Reference Manual

Example
The following example configures the duplex operation of gigabit Ethernet
port 1/0/5 to force full duplex operation.
console(config)# interface gigabitethernet 1/0/5
console(config-if)# duplex full

flowcontrol

Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol
no flowcontrol
Default Configuration
Flow Control is enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In the following example, flow control is enabled.
console(config)# flowcontrol

interface

Use this command to configure parameters for the gigabit Ethernet and ten-
gigabit Ethernet ports, and for port-channels. While in Global Configuration
mode, enter the interface command (with a specific interface). To exit to
Global Configuration mode, enter exit. To return to Privileged EXEC mode,
press Ctrl-Z or enter end.
375
Ethernet Configuration Commands