Configuring none for the limit means the interface is not rate limited for
Dynamic ARP Inspection.
Syntax
ip arp inspection limit { none | rate
no ip arp inspection limit
•
none — To set no rate limit.
pps — The number of packets per second (Range: 0–300).
•
seconds — The number of seconds (Range: 1–15).
•
Default Configuration
The default rate limit is 15 packets per second.
The default burst interval is 1 second.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/0/1)#ip arp inspection limit none
console(config-if-1/0/1)#ip arp inspection limit rate 100
burst interval 2
ip arp inspection trust
The ip arp inspection trust command configures an interface as trusted for
Dynamic ARP Inspection. Use the "no" form of this command to configure
an interface as untrusted.
Syntax
ip arp inspection trust
344
Dynamic ARP Inspection Commands
pps
[ burst interval
seconds
] }