Ip Arp Inspection Vlan - Dell PowerEdge M420 Reference Manual

Default Configuration
There is no additional validation enabled by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ip arp inspection validate src-mac
dst-mac ip
console(config)#ip arp inspection validate src-mac ip
console(config)#ip arp inspection validate dst-mac ip
console(config)#ip arp inspection validate ip

ip arp inspection vlan

Use the ip arp inspection vlan command to enable Dynamic ARP Inspection
on a single VLAN or a range of VLANs. Use the no form of this command to
disable Dynamic ARP Inspection on a single VLAN or a range of VLANs.
Syntax
ip arp inspection vlan
no ip arp inspection vlan
vlan-range — A valid range of VLAN IDs.
•
logging — Use this parameter to enable logging of invalid packets.
•
Default Configuration
Dynamic ARP Inspection is disabled by default.
Command Mode
Global Configuration mode
346
Dynamic ARP Inspection Commands
vlan-range
[ logging ]
vlan-range
[ logging ]