Ip Arp Inspection Filter; Ip Arp Inspection Limit - Dell PowerEdge M420 Reference Manual

Example
console#clear ip arp inspection statistics

ip arp inspection filter

Use the ip arp inspection filter command to configure the ARP ACL to be
used for a single VLAN or a range of VLANs to filter invalid ARP packets. If
the static keyword is given, packets that do not match a permit statement are
dropped without consulting the DHCP snooping bindings. Use the "no" form
of this command to unconfigure the ARP ACL.
Syntax
ip arp inspection filter
no ip arp inspection filter
acl-name —The name of a valid ARP ACL. (Range: 1–31 characters)
•
vlan-range —A valid VLAN range.
•
Default Configuration
No ARP ACL is configured.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip arp inspection filter tier1 vlan 2-10 static
console(config)#ip arp inspection filter tier1 vlan 20-30

ip arp inspection limit

Use the ip arp inspection limit command to configure the rate limit and
burst interval values for an interface.
acl-name vlan-range
vlan
acl-name
vlan
Dynamic ARP Inspection Commands
[static]
vlan-range
[static]
343