Configuring The Switch Module Ethernet Interface - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

Configuring the Switch Module Ethernet Interface

Copyright © 2010, Juniper Networks, Inc.
system:mm[1]> ifconfig —eth0 —i 192.168.171.96 —g 192.168.171.254 —s 255.255.252.0
—c static
In this example, Ethernet channel 0 is configured for a static IP address of
and a gateway address of
NOTE: You only need to configure the Ethernet interface on the primary
management module. The backup management module will use the IP
address from the primary if it becomes the primary management module.
You must configure the Ethernet interface for both JCS switch modules (
) on the JCS management module.
switch[2]
NOTE: The IP address for the JCS switch modules must be on the same
subnet as the IP address for the JCS management module.
To configure the JCS switch module Ethernet interface on the JCS management module:
Log in to the JCS management module.
1.
Use the command to set JCS switch module 1 (
2. env
target. For example:
system> env —T switch[1]
Use the command to configure the interface. For example:
ifconfig
3.
system:switch[1]> ifconfig —i 192.168.171.98 —g 192.168.171.254 —s 255.255.252.0
—em enabled —ep enabled
In this example, the Ethernet interface for JCS switch module 1 is configured for an IP
address of 192.168.171.98
is . The external ports (
255.255.252.0
Repeat this procedure for JCS switch module 2. Use the
4.
module 2 ( switch[2] ) as the configuration target. For example:
system> env —T switch[2]
Use the command to configure the interface. For example:
5. ifconfig
system:switch[2]> ifconfig —i 192.168.171.99 —g 192.168.171.254 —s 255.255.252.0
—em enabled —ep enabled
In this example, the Ethernet interface for JCS switch module 2 is configured for an IP
address of
192.168.171.99
is 255.255.252.0 . The external ports (
Chapter 6: Configuring Basic System Parameters
192.168.171.254 . The subnet mask is
and a gateway address of
) of the switch module are enabled.
ep
and a gateway address of
ep ) of the switch module are enabled.
192.168.171.96
255.255.252.0 .
switch[1]
) as the configuration
switch[1]
192.168.171.254 . The subnet mask
command to set switch
env
. The subnet mask
192.168.171.254
and
41