CHAPTER 52
Configuring Interfaces
Configuring Gigabit Ethernet Interfaces (J-Web Procedure)
Copyright © 2010, Juniper Networks, Inc.
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 1143
Port Role Configuration with the J-Web Interface (with CLI References) on page 1149
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 1153
Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 1156
Configuring Aggregated Ethernet Interfaces (CLI Procedure) on page 1157
Configuring Aggregated Ethernet Interfaces (J-Web Procedure) on page 1158
Configuring Aggregated Ethernet LACP (CLI Procedure) on page 1161
Configuring Unicast RPF (CLI Procedure) on page 1162
Disabling Unicast RPF (CLI Procedure) on page 1163
Configuring IP Directed Broadcast (CLI Procedure) on page 1164
Configuring a Layer 3 Subinterface (CLI Procedure) on page 1165
An Ethernet interface must be configured for optimal performance in a high-traffic
network.
To configure properties on a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface
on an EX Series switch:
Select
>
Interfaces
Ports
1.
The page lists Gigabit Ethernet and 10-Gigabit Ethernet interfaces and their link status.
NOTE: After you make changes to the configuration in this page, you must
commit the changes immediately for them to take effect. To commit all
changes to the active configuration, select
See Using the Commit Options to Commit Configuration Changes for
details about all commit options.
Select the interface you want to configure. If the interface you want to configure is
2.
not listed under
in the top table on the page, select the FPC (the FPC is the line
Ports
.
Commit Options
>
Commit
.
1143