Monitoring the QoS Configuration of Fast Ethernet, Gigabit Ethernet, and 10-Gigabit
Ethernet Interfaces
Display information about the QoS configuration for a specific Fast Ethernet, Gigabit
Purpose
Ethernet, or 10-Gigabit Ethernet interface.
To display the QoS configuration for a Fast Ethernet interface:
Action
host1#show interfaces fastEthernet 6/0
GigEthernet6/0 is Up, Administrative status is Up
Hardware is Intel 21440, address is 0090.1a40.5508
MAU is 100BASE-TX
MTU: Operational 1522, Administrative 1522
Duplex Mode: Operational Full Duplex, Administrative Auto Negotiate
Speed: Operational 100 Mbps, Administrative Auto Negotiate
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 0, Unicast 0
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Out: Bytes 64, Unicast 0
Multicast 0, Broadcast 1
Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 0
Collisions: Single 0, Multiple 0, Late 0, Excessive 0
Administrative qos-shaping-mode: cell
Operational qos-shaping-mode: cell
Attached QoS profile: ss
To display the QoS configuration for a Gigabit Ethernet interface:
host1#show interfaces gigabitEthernet 2/0
To display the QoS configuration for a 10-Gigabit Ethernet interface:
host1#show interfaces tenGigabitEthernet 5/0/0
Table 51 on page 348 lists the related show interfaces command output fields.
Meaning
Monitoring the QoS Configuration of Fast Ethernet, Gigabit Ethernet, and 10-Gigabit Ethernet Interfaces
Creating Parameter Instances
show ip interface
Chapter 31: Monitoring QoS on E Series Routers
347