Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 252

JUNOS 10.1 Network Interfaces Configuration Guide
182
Protocol Family Configuration and Interface Address Statements
filter {
dialer filter-name;
input filter-name;
output filter-name;
group filter-group-number;
}
interface-mode (access | trunk);
ipsec-sa sa-name;
keep-address-and-control;
mtu bytes;
multicast-only;
negotiate-address;
no-redirects:
policer {
arp policer-template-name;
input policer-template-name;
output policer-template-name;
}
primary;
protocols [inet iso mpls];
proxy inet-address address;
receive-options-packets;
receive-ttl-exceeded;
remote (inet-address address | mac-address address);
rpf-check <fail-filter filter-name>;
sampling {
direction;
}
service {
input {
service-set service-set-name <service-filter filter-name>;
post-service-filter filter-name;
}
output {
service-set service-set-name <service-filter filter-name>;
}
}
(translate-discard-eligible | no-translate-discard-eligible);
(translate-fecn-and-becn | no-translate-fecn-and-becn);
vlan-id number;
vlan-id-list [number number-number];
unnumbered-address interface-name destination address destination-profile
profile-name;
address address {
arp ip-address (mac | multicast-mac) mac-address <publish>;
broadcast address;
destination address;
destination-profile name;
eui-64;
multipoint-destination address dlci dlci-identifier;
multipoint-destination address {
epd-threshold cells;
inverse-arp;
oam-liveness {
up-count cells;
down-count cells;