Disabling A Logical Interface - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Disabling a Logical Interface

You can unconfigure a logical interface, effectively disabling that interface, without
removing the logical interface configuration statements from the configuration. To
do this, include the
You can include this statement at the following hierarchy levels:
When an interface is disabled, a route (pointing to the reserved target "
the IP address of the interface and a 32–bit subnet mask is installed in the routing
table. See Routing Protocols.
dynamic-call-admission-control {
bearer-bandwidth-limit 900 kbps;
activation-priority 75;
}
}
}
}
disable
disable;
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
Chapter 4: Configuring Logical Interface Properties
statement:
Disabling a Logical Interface
REJECT ") with
179