Table of Contents
Advertisement
JUNOS 10.1 Network Interfaces Configuration Guide
To configure an IPv4 address on JUNOS routers, use the
unit number family
level.
NOTE: Juniper Networks routers support /31 destination prefixes when used in
point-to-point Ethernet configurations; however, it is not supported by many other
devices, such as hosts, hubs, or routers. You must determine if the peer system also
supports /31 destination prefixes before configuration.
Configuring the Interface IPv6 Address
You represent IPv6 addresses in hexadecimal notation using a colon-separated list
of 16-bit values.
You assign a 128-bit IPv6 address to an interface by including the
You can include this statement at the following hierarchy levels:
The double colon (
NOTE: You must manually configure the router advertisement and advertise the
default prefix for autoconfiguration to work on a specific interface.
Configuring ICCP for MC-LAG
For Multi-Chassis Link Aggregation (MC-LAG), you must configure Internet Chassis
Control (ICCP) to exchange information between two MC-LAG peers.
To enable ICCP, include the
188
Configuring ICCP for MC-LAG
address a.b.c.d/nn
<inet>
address aaaa:bbbb:...:zzzz/nn;
[edit interfaces interface-name unit logical-unit-number family inet6]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number family inet6]
) represents all bits set to 0, as shown in the following example:
::
interfaces fe-0/0/1 {
unit 0 {
family inet6 {
address fec0:1:1:1::2/64;
}
}
}
[edit protocols]
iccp {
authentication-key string;
local-ip-addr ipv4-address;
statement at the
statement at the
iccp
[edit protocols]
edit interface interface-name
[edit interfaces]
hierarchy
statement:
address
hierarchy level:
Advertisement
Table of Contents
