Table of Contents
Advertisement
JUNOS 10.1 Network Interfaces Configuration Guide
You can include these statements at the following hierarchy levels:
For more information about configuring PAP for physical interfaces, see "Configuring
the PPP Password Authentication Protocol" on page 126. For information about
configuring tracing operations for the PPP protocol, see "Tracing Operations of the
pppd Process" on page 131.
On each logical interface with PPP encapsulation, you can perform the following
tasks:
Configuring a Default PAP Password
The default PAP password is used when no matching PAP access profile exists, or if
the PAP access profile name changes during PPP link negotiation.
To configure a default PAP password for an interface, include the
statement:
You can include the statement at the following hierarchy levels:
Configuring the Local Name
By default, when PAP is enabled on an interface, the interface uses the router s
system hostname as the name sent in PAP request and response packets.
To configure the name the interface uses in PAP request and response packets,
include the
You can include the statement at the following hierarchy levels:
176
Configuring PPP PAP Authentication
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
Configuring a Default PAP Password on page 176
Configuring the Local Name on page 176
Configuring the Local Password on page 177
Configuring Passive Mode on page 177
default-pap-password password;
[edit interfaces interface-name unit logical-unit-number ppp-options pap]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number ppp-options pap]
statement:
local-name
local-name name;
[edit interfaces interface-name unit logical-unit-number ppp-options pap]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number ppp-options pap]
default-pap-password
Advertisement
Table of Contents
