The following example shows the arrow head selected for editing.
3. When the move is complete, lift your finger to commit the change.
To Delete an Annotation
1. On the Annotations panel, tap the measurement you want to delete.
2. Tap the Delete button displayed below the selected annotation. The annotation will be immediately
deleted.
3. If you want to delete all of the annotations on the selected image, tap Delete All. located at the
bottom of the Annotation panel. You will be prompted to confirm the deletion of all annotations.
The annotation(s) are deleted from the image and the Annotations panel.
Measurements
The Vevo Imaging System offers several types of generic measurements.
This section lists available generic measurements, and describes how to a dd each one.
Note:
Available measurements vary depending on the currently selected imaging
mode. Measurements are only available for imaging modes that support them.
When adding generic measurements, please note the following:
Measurements will be displayed on the image display and the control panel.
l
Measurements can be placed on a saved image loaded into review, any image that has been
l
acquired during an acquisition session and an image that is in the zoom state.
Placing or editing a measurement will automatically save the image.
l
If the unit value includes more than four digits before the decimal point, the unit of measure changes
l
so that the value will have less than four digits displayed.
Note:
Protocol measurements are only available on Vevo LAB.
Session Tasks
Vevo F2 Imaging System User Manual
61