FujiFilm VisualSonics Vevo F2 User Manual page 399

2. Speak in a normal voice, then adjust the volume slider until the colored meter appears in the green
zone.
If the voice is too quiet (meter fills to the left and is yellow), move the volume slider to the right.
o
If the voice is too loud (meter fills to the right and is red), move the volume slider to the left.
o
3. Once the volume is set correctly, read the training phrase (in the Training Phrase box).
The system will learn your reading of the phrase, then show a new phrase.
4. Continue to read training phrases until training stops and the Stop Training button changes to
Continue Training.
5. When the Continue Training button appears, you have completed the first set of training phrases.
To continue training with a new set of phrases, tap Continue Training.
6. Continue reading training phrases and tapping Continue Training for new sets of phrases until the
training stops and the button changes back to Start Training. This indicates that you have
completed training for all phrases.
You can tap Stop Training to pause voice training at any time and resume training by tapping Continue
Training later.
Start Voice Testing
Once training is complete, you can test Vevo Voice's ability to recognize your phrases before you use them
during a scanning session.
To test Vevo Voice, tap Start Testing and then say any voice command.
Note: For a list of commands, refer to Vevo Voice Commands on page 104.
System Settings
Vevo F2 Imaging System User Manual
399