Table of Contents
Advertisement
Adjust Image
To adjust the image currently displayed, use the imaging controls on the control panel.
Image adjustment controls vary between modes. For more information about the image adjustment controls
for a particular mode, refer to the list of controls for that mode. For example, for B-Mode controls, refer to B-
Mode Control Panel Interface on page 109.
Freeze Image/Resume Scanning
Certain tasks, such as viewing a clip or adding measurements, require you to stop live imaging by freezing
the image.
To freeze t he image at any time, tap FREEZE.
When an image is frozen, the bottom bar of the control panel changes to a Slide to Scan slider.
To resume live imaging, drag the green arrow in the Slide to Scan slider to the right.
Using the Slide to Scan slider returns the interface to the live image.
Insert Markup
There are several types of markup that can be added to an image:
Measurements on page 61: A marker highlighting a measurement, such as angle or distance.
l
Annotations on page 56: User-entered notes that are embedded into the image.
l
Change Controls on Control Panel
Most buttons along the left, bottom, and right bars on the control panel are interchangeable. Users can
move and swap buttons on each of these bars to ensure that their most commonly used controls are in
convenient places.
All buttons that are not on the control panel are stored in the More Controls menu.
For more information, refer to Customizing the Control Panel on page 91.
Save an Image or Clip
Images can be saved as single frames, or as video clips. This can be done at any time during an imaging or
review session.
For more information, refer to Saving Images on page 98.
Session Tasks
Vevo F2 Imaging System User Manual
44
Hide quick links:
Advertisement
Table of Contents
