To Turn On The Laser Cart - FujiFilm VisualSonics Vevo F2 User Manual

3. Turn on the main power switch located at the back of the system, next to where the power cord
connects to the base.
4. Press the power button located behind the control panel, near the transducer holders.
To Turn On the Laser Cart
If using the Vevo LAZR-X laser cart, follow these steps to turn on the laser cart after turning on the Vevo F2.
1. Connect an AC power cord to the power outlet located at the back of the cart.
2. Ensure the emergency stop button is disengaged (rotate it clockwise if it is not).
3. Connect the other end of the AC power cord into a wall outlet with the proper plug.
4. Turn on the main power switch on the back of the laser cart.
5. Confirm the following cables are connected from the system to the laser cart. If using a Vevo
LAZRTight, refer to the diagram below.
Vevo LAZR-X laser cart
Q Trig In
Lamp Sync Out
RS232/Remote
Introduction
Location of the power button
Trig Out
Trig In
USB
Vevo F2 Imaging System User Manual
Vevo F2
24