FujiFilm VisualSonics Vevo F2 User Manual page 70

Note:
that was visible on the control panel when you tapped the Graph icon. If the
area measurement was obscured in any way (such as if the control panel
was zoomed in to not fully show the Area measurement), the histogram
displayed will not be accurate. If this happens, zoom back out and make
sure the entire measurement is visible on screen before tapping the Graph
icon again.
3. Tap Close to return to the image.
Distance
Distance measurements are available in B-Mode, PA-Mode, Color Doppler Mode, Power Doppler Mode,
and Nonlinear Contrast Mode.
To Add a Distance Measurement
1. Tap Measurements.
2. Tap Distance.
An active anchor for the measurement is placed on the image.
3. Tap and drag the anchor point to the desired location on the image.
4. Tap Set when you have placed your anchor at the desired start location.
5. Tap and drag the anchor point to trace the distance on the image area.
Session Tasks
The histogram is calculated based on the part of the measurement
Vevo F2 Imaging System User Manual
70