FujiFilm VisualSonics Vevo F2 User Manual page 104

Note: When "Constantly On" is enabled, the Vevo Voice icon will show that it is
listening.
Note: The foot pedal can also be set as a toggle for Vevo Voice. For more
information, refer to Foot Pedal Configuration.
Vevo Voice Commands
To give a command with Vevo Voice, say "Vevo" and then say the desired command. For example, to
switch to B-Mode, say "Vevo switch to B-Mode."
If the "User Controlled" voice option is selected in the System Settings menu, you must tap the Vevo Voice
control before staying "Vevo <command>". Similarly, if using a foot pedal to activate Vevo Voice, you must
press the voice pedal before giving a command.
The following voice commands are available (some commands are only available in certain modes):
Command
Freeze Pauses scanning.
Plays or pauses the clip.
Play
Not available in spectrum-based scanning modes (PW Doppler Mode and
Pause
PW Tissue Doppler Mode).
Next Image Loads the next or previous image.
Previous Image Only available when viewing a frame-based clip.
Save Clip Saves the acquired data as a clip.
Save Frame Saves the current frame.
Scan Starts scanning in the current mode.
Switches to the mode above the current mode, according to the list of mode
Next Mode
buttons on the left of the control panel.
Start Recording Starts recording in the current mode.
Session Tasks
Vevo F2 Imaging System User Manual
Action
104