FujiFilm VisualSonics Vevo F2 User Manual page 443

Tap Yes to continue the installation.
o
Tap No to cancel the installation.
o
8. After tapping Yes, the a message appears, informing you that the system will now restart to continue
the upgrade.
9. Tap OK to continue the installation.
10. Once the system has fully shutdown, power on the system by pressing the power button near the
rear-right corner of the system.
11. Once the system restarts, installation will continue. Continue to follow the on-screen instructions.
Note:
12. Restart the system and verify the installed version on the System Information page.
13. Remove the USB storage device f rom the USB port on the system.
License Update
Your system license and enabled features are mapped to your specific machine, as identified by the
machine ID. To update your license and enable new features, you need to:
1. Export your Machine ID and send it to Technical Support (refer to Contact and Legal Information on
page 477)
2. Receive a new license file from Technical Support.
3. Use the updated license file to update your system.
To Export Your Machine ID
1. Open the System Information menu, and navigate to the System Information tab.
2. Tap Export Machine ID.
Maintenance
Note: It may take up to one minute before the screen starts showing
the installation progress.
Caution: DO NOT start any acquisition sessions during the upgrade
process.
DO NOT manually reboot the system while the system is upgrading.
Vevo F2 Imaging System User Manual
443