To Edit a Measurement
Once a measurement is placed, you can edit individual anchor points along the measurement. After you
edit a measurement, the system software automatically saves the image.
Note:
Not all measurements can be modified after being placed. If you cannot
modify a measurement, delete the measurement and add it again.
To edit a measurement:
1. Tap the measurement on the image or on the Measurements panel. The measurement will change
color from cyan to white.
2. Tap and drag one of the measurement anchor points to the desired position. The measurement
parameters automatically update on the Measurements panel.
Note:
Moving a measurement anchor point for a depth or time measurement will
also allow you to change the location of the measurement at the same time.
To Move a Measurement
Once a measurement is placed, you can move the entire measurement to a different location on the image
while maintaining its original measurement value. The image is saved automatically after you have moved
your measurement.
1. Tap the measurement on the image or on the Measurement panel. When the measurement is active,
it changes color to white.
2. If the measurement has a center anchor point, tap the center of the measurement. If there is no
Session Tasks
Vevo F2 Imaging System User Manual
65
Need help?
Do you have a question about the VisualSonics Vevo F2 and is the answer not in the manual?